Javorek, LubomirVargovská, Maria2021-09-272021-09-272021-09-27International Journal of Engineering and Management Sciences, Vol. 6 No. 2 (2021) , 257-265https://hdl.handle.net/2437/322004In this contribution are results from machining of the aluminium alloy by spiral router. The experiment was designed as full 3 - factors and 2-levels process and for evaluation of input factors to output parameters – Fx and Fy components were used Paret´s diagram and Lorentz´s line. The input parameters were: revolution speed (4000/min. and 6000/min.), working engagement of a cutting edge (depth of cut) a e (1 mm and 3 mm), back engagement of a cutting edge (with  of cut) a p (5 mm and 15 mm) and down (climb) milling.In this contribution are results from machining of the aluminium alloy by spiral router. The experiment was designed as full 3 - factors and 2-levels process and for evaluation of input factors to output parameters – Fx and Fy components were used Paret´s diagram and Lorentz´s line. The input parameters were: revolution speed (4000/min. and 6000/min.), working engagement of a cutting edge (depth of cut) a e (1 mm and 3 mm), back engagement of a cutting edge (with  of cut) a p (5 mm and 15 mm) and down (climb) milling.application/pdfmachiningforcesdesign of experimentsmachiningforcesdesign of experimentsfolyóiratcikkOpen AccessLubomir Javorek, Vargovskáhttps://doi.org/10.21791/IJEMS.2021.2.22.International Journal of Engineering and Management Sciences262498-700X